Yamaha QL5 Firmware Update Guide - Page 9

■ Updating the Dante firmware Described below are the procedures to update the Dante module firmware integrated in the QL series unit. ・ For details of the Dante Firmware Update Manager, refer to "AUD-MAN-Firmware Update Manager" stored in the compressed file folder. 1. Connect the Dante [PRIMARY] connector on the rear panel of the QL series unit to the Ethernet connector on the computer using an Ethernet cable. Be sure to directly connect the computer and the QL series unit, and do not connect any other Dante device to the computer. 2. Select [Start]→[All programs]→[Audinate]→[Dante Firmware Update Manager]→[Dante Firmware Update Manager ] , then right-click and select "Run as Administrator." The Dante Firmware Update Manager will start up. Check that the version number is 1.3.2 or higher from the title bar. ・ When running under Windows 7, the "User Account Control" dialog box may appear. Click [Continue] or [Yes]. 3. If you see the interface selection screen, select the interface card to connect the Dante device. 4. Click [Update Dante Firmware]. 5. Click [Browse] and select "FWUpdate_QL5_vxxx_swyyy.dnt" if it is QL5, or "FWUpdate_QL1_vxxx_swyyy.dnt" if QL1. Then click [Open]. xxx and yyy represent the firmware version number. ・ The Dante firmware does not operate normally if its path contains any multi-byte character (including Japanese characters). If you use a directory name containing any multi-byte character in your computer, store the firmware update files in a directory that consists only of ASCII characters (e.g. C:\temp). Be sure to ensure compatibility of the update files with QL. If update files other than QL are applied, the device will become inoperable. In general, do not check the [Override Device Matching] option. If this option is left unchecked, only devices that support the file can be selected, ensuring that updating the device with invalid or wrong files is prevented. QL5/QL1 Firmware Update Guide 9