Yamaha QY70 List Book - Page 45
Omni Mode Off Control Number = 7ch, Data Value = 0
View all Yamaha QY70 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
MIDI Data Format SOFT PEDAL NRPN RPN PORTAMENT CONTROL 0 (off) Un-set status. Internal data will not change. Un-set status. Internal data will not change. reset The following data will not change. PROGRAM CHANGE, BANK SELECT MSB/LSB, VOLUME, PAN. HARMONIC CONTENT, RELEASE TIME, ATTACK TIME, BRIGHTNESS, DRY SEND LEVEL, EFFECT SEND LEVEL 1, EFFECT SEND LEVEL 3, EFFECT SEND LEVEL 4, PITCH BEND SENSITIBITY, FINE TUNING, COURSE TUNING (3-2-3) ALL NOTE OFF (CONTROL NUMBER = 7BH , DATA VALUE = 0) Turns off all notes of the corresponding channel which are on. However if Sustain or Sostenuto are on, the sound will continue until these are turned off. (3-2-4) OMNI MODE OFF (CONTROL NUMBER = 7CH , DATA VALUE = 0) Performs the same processing as when ALL NOTE OFF is received. Sets the VOICE RECEIVE CHANNEL to OMNI OFF and CHANNEL = 1. (3-2-5) OMNI MODE ON (CONTROL NUMBER = 7DH , DATA VALUE = 0) Performs the same processing as when ALL NOTE OFF is received. Does not set OMNI ON. Sets the VOICE RECEIVE CHANNEL to OMNI ON. (3-2-6) MONO (CONTROL NUMBER = 7EH , DATA VALUE = 0) Performs the same processing as when All SOUND OFF is received, and if the 3rd byte (mono number) is in the range 0-16, sets the corresponding channel to Mode 4 (m=1). If in the VOICE MODE, Mode 2 (m=1) is also possible, according to the VOICE RECEIVE CHANNEL. (3-2-7) POLY (CONTROL NUMBER = 7FH , DATA VALUE = 0) Performs the same processing as when ALL SOUND OFF is received, and sets the corresponding channel to Mode 3. When in the VOICE MODE, Mode 1 is also possible, according to the VOICE RECEIVE CHANNEL. (3-3) REGISTERED PARAMETER NUMBER STATUS 1011nnnn (BnH) LSB 01100100 (64H) RPN LSB 0ppppppp MSB RPN MSB DATA ENTRY MSB DATA VALUE DATA ENTRY LSB DATA VALUE 01100101 (65H) 0qqqqqqq 00000110 (06H) 0mmmmmmm 00100110 (26H) 0lllllll n = 0 ~ 15 VOICE CHANNEL NUMBER p = RPN LSB (Refer to the table on the following page.) q = RPN MSB (Refer to the table on the following page.) m = Data Value l = Data Value First transmit an RPN MSB and RPN LSB to specify the parameter that is to be controlled, then use Data Entry to set the value of the specified parameter. RPN LSB MSB 00H 00H 01H 00H 02H 00H 7FH 7FH D.ENTRY MSB LSB mmH - mmH llH mmH - - - PARAMETER NAME PITCH BEND SENSITIVITY MASTER FINE TUNE MASTER COARSE TUNE RPN RESET DATA RANGE 00H - 18H (0 - 24 semitones) {mmH,llH} = {00H,00H} - {40H,00H} - {7FH,7FH} (-8192*100/8192) - 0 - (+8192*100/8192) 28H - 40H - 58H (-24 - 0 - +24 semitones) Set to a condition in which the RPN number is unspecified. Internal settings will not change. 45