Yamaha QY70 List Book - Page 46

MIDI Data Format (3-4) NON-REGISTERED PARAMETER NUMBER STATUS 1011nnnn (BnH) LSB 01100010 (62H) RPN LSB MSB RPN MSB DATA ENTRY MSB DATA VALUE 0ppppppp 01100011 (63H) 0qqqqqqq 00000110 (06H) 0mmmmmmm n = 0 ~ 15 VOICE CHANNEL NUMBER p = NRPN LSB (Refer to the table on the following page.) q = NRPN MSB (Refer to the table on the following page.) m = Data Value First transmit an NRPN MSB and NRPN LSB to specify the parameter that is to be controlled, then use Data Entry to set the value of the specified parameter. NRPN MSB LSB 01H 08H 01H 09H 01H 0AH 01H 20H 01H 21H 01H 63H 01H 64H 01H 66H 14H rrH 15H rrH 16H rrH 17H rrH 18H rrH 19H rrH 1AH rrH 1CH rrH 1DH rrH 1EH rrH 1FH rrH D.ENTRY MSB LSB mmH - mmH - mmH - mmH - mmH - mmH - mmH - mmH - mmH - mmH - mmH - mmH - mmH - mmH - mmH - mmH - mmH - mmH - mmH - PARAMETER NAME VIBRATO RATE VIBRATO DEPTH VIBRATO DELAY FILTER CUTOFF FREQUENCY FILTER RESONANCE EG ATTACK TIME EG DECAY TIME EG RELEASE TIME DRUM INST FILTER CUTOFF FREQ. DRUM INST FILTER RESONANCE DRUM INST AEG ATTACK RATE DRUM INST AEG DECAY RATE DRUM INST PITCH COARSE DRUM INST PITCH FINE DRUM INST LEVEL DRUM INST PANPOT DRUM INST REVERB SEND LEVEL DRUM INST CHORUS SEND LEVEL DRUM INST VARIATION SEND LEVEL DATA RANGE 00H - 40H - 7FH (-64 - 0 - +63) 00H - 40H - 7FH (-64 - 0 - +63) 00H - 40H - 7FH (-64 - 0 - +63) 00H - 40H - 7FH (-64 - 0 - +63) 00H - 40H - 7FH (-64 - 0 - +63) 00H - 40H - 7FH (-64 - 0 - +63) 00H - 40H - 7FH (-64 - 0 - +63) 00H - 40H - 7FH (-64 - 0 - +63) 00H - 40H - 7FH (-64 - 0 - +63) 00H - 40H - 7FH (-64 - 0 - +63) 00H - 40H - 7FH (-64 - 0 - +63) 00H - 40H - 7FH (-64 - 0 - +63) 00H - 40H - 7FH (-64 - 0 - +63) 00H - 40H - 7FH (-64 - 0 - +63) 00H - 7FH (0 - maximum) 00H, 01H - 40H - 7FH (random, left - center - right) 00H - 7FH (0 - maximum) 00H - 7FH (0 - maximum) 00H - 7FH (0 - maximum) MSB 14h-1Fh (for drum) are valid only if the channel is set to Drum Set Mode. rrH : drum instrument note number (3-5) SYSTEM REAL TIME MESSAGES (3-5-1) ACTIVE SENSING STATUS 11111110 (FEH) Transmitted at intervals of approximately 200 msec. Once this message is received, SENSING will begin. If neither STATUS nor DATA messages are received for an interval longer that approximately 350 msec, the MIDI RECEIVE BUFFER will be cleared, and all sounding notes and SUSTAIN SWITCH will be forced off. Also, data for each of the controls will be reset to specific values. (3-6) SYSTEM EXCLUSIVE MESSAGE (3-6-1) UNIVERSAL NON REALTIME MESSAGE (3-6-1-1) GENERAL MIDI MODE ON F0H 7EH 7FH 09H 01H F7H The following controller values will be reset. VOLUME PAN PROGRAM CHANGE BANK SELECT MSB 100 Center 1 (Grandpno) 0 46