Yamaha REV500 REV500 Owners Manual - Page 13
Changing the Effect Level, Realtime Parameter Control, Editing Internal Parameters, Changing
View all Yamaha REV500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Changing the Effect Level You can also use the ER LEVEL control to adjust the effect level, that is, the level of the total effect output. To do so, press the EFF LEVEL key before turning the ER LEVEL control. The LED above this key will light, and (as with the other basic parameters) the program information in the LCD will be replaced by a graphic display. You can set a level from 0 to 100. Use the PRE DELAY control to move the cursor from the parameter name to the parameter value and vice-versa. Use the REV TIME control to select the parameter you wish to edit, and to adjust the value assigned to the parameter you select. Please note that the parameters available for editing will vary with the effect type of the program you have selected. You can identify the effect type of a program by checking the upper right corner of the LCD. Effect type Realtime Parameter Control The REV500 also lets you dynamically change the aforementioned basic parameters in realtime, using MIDI Control Change messages. The controller numbers for these parameters are shown in the table below. MIDI Controller Numbers Parameter PRE DELAY REV TIME HI-RATIO ER LEVEL EFF LEVEL Ctrl. No. 12 13 14 15 16 Refer to the next section for a list of the internal parameters for each effect type. When you are done editing internal parameters, press one of the PROGRAM keys to exit the utility mode. Remember that (as with other program parameters) you must save the program you have just edited before selecting another program or turning the REV500 off, or your changes will be lost. Refer to page 13 for instructions on how to store a program. Changing a Program's Title You can assign a program you have edited a new title, for easy recognition. To edit a program's title, begin by pressing the UTILITY key. The LED above this key will light, and one of the REV500's utility function displays will appear in the LCD. If necessary, press the UTILITY key again until the TITLE EDIT display appears: Editing Internal Parameters In addition to the basic parameters described previously, the REV500's programs have a variety of internal parameters that can also be edited. To edit a program's internal parameters, press the UTILITY key. If necessary, press the UTILITY key again until the INT. PARAMETER display appears: Cursor Value Parameter name Cursor Use the PRE DELAY control to select a character you wish to change, and the REV TIME control to change that character. Repeat this process until the title appears as you wish it to read. When you are done editing the title, press one of the PROGRAM keys to exit the utility mode. Remember that (as with other program parameters) you must save the program you have just edited before selecting another program or turning the REV500 off, or your new title will be lost. Refer to page 13 for instructions on how to store a program. 9