Yamaha REX50 REX50 Owners Manual Image - Page 8
General, Operation
View all Yamaha REX50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
2: GENERAL OPERATION / MEMORY CONFIGURATION The REX50 has a total of 90 internal memory locations. Locations 1 through 30 are READ-ONLY MEMORY containing the 30 preset effect programs. These locations cannot be written to or changed in any way. The effect programs contained ih memory locations 1 through 30 are: MNoom. ' Program Name Meom. ' Program Name N 1 REV 1 HALL 16 REVERB & GATE 2 REV 2 ROOM 17 PITCH CHANGE A 3 REV 3 VOCAL 18 PITCH CHANGE B 4 REV 4 PLATE 19 PITCH CHANGE C 5 EARLY REF. 1 20 PAN 6 GATE REVERB 21 DISTORTION 7 DELAY L,R 22 DIST.+REV HALL 8 STEREO ECHO 23 DIST.+REV PLATE 9 STEREO FLANGE 24 DIST. +GATE REV 10 CHORUS 25 D.+REVERSE GATE 11 STEREO PHASING 26 DIST. +DELAY 12 SYMPHONIC 27 DIST. + ECHO 13 REVERSE GATE 28 DIST. +FLANGE 14 ADR-NOISE GATE 29 DIST. +CHORUS 15 COMPRESSOR 30 DIST.+SYMPHONIC A complete description of each effect program and its parameters is given in "3: DESCRIPTIONS OF THE EFFECT PROGRAMS & THEIR PARAMETERS" on page 10. Locations 31 through 90 are READ/WRITE MEMORY which can be used to store your own edited versions of the preset programs. I SELECTING AN EFFECT/MEMORY LOCATION ®Press the MEMORY key to engage the memory selection mode. This is not necessary if the memory selection mode is already active, but it's a good habit to get into to ensure smooth operation. ()Press the A or V key to increment or decrement the memory location number shown on the LED display. Hold either of these keys down for continuous incrementing or decrementing. The name of the program corresponding to the currently selected memory location will be shown on the LCD, or "*** NO DATA ** *" will be displayed if a memory location between 31 and 90 is selected into which an edited effect program has not been stored. Note that at this stage the LED memory number display is flashing, indicating that although a new location has been selected, its contents have not yet been 7 recalled. @ When the desired memory location/effect has been selected, press the RECALL key. The LED memory number display will stop flashing and the selected effect will be engaged. MEMORY COMPRESSOR I _I 6 I N\ I STEREO ECHO -flash- Selected Effect RECALL STEREO ECHO 11 11 / BYPASSING THE EFFECT There are two ways to switch the selected effect in and out: ® with the control panel BYPASS switch and ® with a footswitch connected to the connector-panel BYPASS footswitch jack. An optional Yamaha FC5 Footswitch can be used for foot-bypass control. In either case - when the control-panel BYPASS key or BYPASS footswitch is pressed - a bold, flashing letter "B" will appear in the upper right-hand corner of the LCD. While the "B" is visible the REX50 effect is bypassed and the input signal is directly routed to the output terminals (i.e. the effect is OFF). Press the BYPASS key or footswitch a second time to turn the effect back ON.