Yamaha RX-396 Owner's Manual - Page 5
Notes About The Remote Control Transmitter
View all Yamaha RX-396 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
English WARNING Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise this unit may be damaged. IF THIS UNIT FAILS TO TURN ON WHEN THE STANDBY/ON SWITCH IS PRESSED; The IMPEDANCE SELECTOR switch may not be set to either end. If so, set the switch to either end when this unit is in the standby mode. IMPEDANCE SELECTOR (U.S.A. model) A OR B:4ΩMIN. /SPEAKER A B:8ΩMIN. /SPEAKER A OR B: 6ΩMIN. /SPEAKER A B: I2ΩMIN. /SPEAKER IMPEDANCE SELECTOR SET BEFORE POWER ON A NOTES ABOUT THE REMOTE CONTROL TRANSMITTER Battery installation Remote control transmitter operation range 2 1 3 l6 20 28 l2 8 40 4 60 2 0 -dB Remote control sensor Battery replacement If you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones. Notes q Use only AA, R6, UM-3 batteries for replacement. q Be sure the polarities are correct. (See the illustration inside the battery compartment.) q Remove the batteries if the remote control transmitter is not used for an extended period of time. q If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries. Within approximately 6 m (19.7 feet) 30° 30° Notes q There should be no large obstacles between the remote control transmitter and the main unit. q If the remote control sensor is directly illuminated by strong lighting (especially an inverter type of fluorescent lamp etc.), it might cause the remote control transmitter not to work correctly. In this case, reposition the main unit to avoid direct lighting. 5