Yamaha RX-A3070 RX-A3070/RX-A2070 Owners Manual - Page 163

(When using Wireless Direct) SSID Security Security Key IP Address Subnet Mask MAC Address (Wi-Fi) MusicCast Network Network Connection The SSID of the wireless network Security method Security key IP address Subnet mask MAC address The status of the MusicCast network connection "Wireless Direct" indication ■ System Displays the system information on the unit. Remote ID TV Format Speaker Impedance Tuner Freq. Step System ID Firmware Version The unit's remote control ID setting (p.165) The unit's video signal type (p.165) The speaker impedance setting of the unit (p.164) (Brazil, Asia and General models only) The FM/AM tuning frequency setting of the unit (p.165) System ID number The version of firmware installed on the unit X If the unit detects a newer firmware over the network, (mail icon) appears at the upper right of the "Information" and "System" icons, and the corresponding message will be displayed in this screen. You can update the unit's firmware by pressing ENTER in this screen and following the procedure in "Updating the unit's firmware via the network" (p.171). ■ Multi Zone Displays information about Zone2, Zone3 and Zone4. Input Volume The input source selected for Zone2, Zone3 or Zone4 The volume for Zone2 or Zone3 Configuring the system settings (ADVANCED SETUP menu) Configure the system settings of the unit while viewing the front display. 1 Set the unit to standby mode. 2 While holding down STRAIGHT on the front panel, press MAIN ZONE z. MAIN ZONE z STRAIGHT PROGRAM 3 Press PROGRAM to select an item. 4 Press STRAIGHT to select a setting. 5 Press MAIN ZONE z to set the unit to standby mode and turn it on again. The new settings take effect. En 163