Yamaha RX-E100 Owner's Manual - Page 10

RX-E100 BASIC OPERATIONS Listening to a source PHONES TREBLE VOLUME NATURAL SOUND STEREO RECEIVER RX-E100 VOLUME TIMER STANTBY DISPLAY MEMORY AUTO/MAN'L PRESET/BAND PRESET/TUNING STANDBY/ON PHONES TIME ADJ TIMER BASS HOUR PTY SELECT MIN TREBLE BALANCE MIN MAX INPUT -+ -+ LR STANDBY/ON BASS BALANCE INPUT SLEEP A REP D PEAK TIME B RNDM DISP C PROG E TAPE POWER FREQ PS/PTY/RT/CT PTY SEEK MODE START VOLUME TAPE MD AUX CD TUNER MD REC PRESET PTY SELECT TAPE REC TAPE VOLUME -/+ MODE DUBBING START 1 Set the volume to "MIN" by turning VOLUME. 2 Turn on the power by pressing STANDBY/ON on the front panel, or POWER on the remote control. • RX-E100 can be used to turn on or put in standby mode the system connected E100 series components depending on their prior standby/on status. 3 Select the desired input source by turning INPUT so that the source appears on the display. • When you operate the component connected to the AUX terminal, turn INPUT to select AUX. E-8 4 Play the source. (Refer to the owner's manual supplied with each selected component.) 5 Adjust the volume level by turning VOLUME on the front panel or pressing VOLUME + on the remote control. 6 If desired, adjust BASS, TREBLE, and BALANCE. BASS: Turn this control clockwise to increase (or counterclockwise to decrease) the low frequency response. TREBLE: Turn this control clockwise to increase (or counterclockwise to decrease) the high frequency response. BALANCE: Adjust the balance of the output volume from the left and right speakers to compensate for sound imbalance caused by the speaker location or listening room conditions • These controls are only effective for the sound from the main speakers. When you use headphones Connect the headphones to the PHONES jack. You can listen to the sound from the main speakers through the headphones. When you have finished using this unit Press STANDBY/ON on the front panel again or POWER on the remote control to set this unit to the standby mode. • The STANDBY indicator lights up. Auto power off function RX-E100 will be put automatically into the standby mode under the following conditions: • The component connected to RX-E100 is in stop mode and not operated for 30 minutes. • TUNER or AUX is not selected as an input source.