Yamaha RX-S600D RX-S600/RX-S600D Owners Manual - Page 33
To start the measurement, use the cursor keys to, to select SAVE and press ENTER.
View all Yamaha RX-S600D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
1 2 3 4 5 6 7 8 9 10 SOURCE RECEIVER HDMI 1 2 3 4 5 AV AUDIO 1 2 3 1 V-AUX 4 5 2 USB NET FM AM MAIN ZONE 2 PARTY BD DVD SCENE TV NET RADIO RECEIVER PROGRAM MUTE VOLUME TOP MENU SETUP POP-UP/MENU OPTION ENTER RETURN MODE TUNING DISPLAY MEMORY PRESET MOVIE MUSIC SUR. DECODE STRAIGHT ENHANCER DIRECT INFO SLEEP 1 2 3 4 5 6 7 8 9 INPUT MUTE 0 10 TV TV VOL TV CH ENT CODE SET SETUP Cursor keys ENTER RETURN • To cancel the operation, disconnect the YPAO microphone, or use the cursor keys to select "Exit" and press ENTER, before starting the measurement. • To change the internal amplifier assignment, use "Power Amp Assign" (p.81) in the "Setup" menu. • Do not stand between the speakers and the YPAO microphone during the measurement process (about 3 minutes). • Move to the corner of the room or leave the room. 5 To start the measurement, use the cursor keys to select "Start" and press SETUP. The measurement will start in 10 seconds. Press ENTER to start the measurement immediately. • To stop the measurement temporarily, press RETURN and follow the procedure in "Error messages" (p.34). • If cursor keys do not work, the remote control may be set to the external device operation mode. In this case, press RECEIVER to set the remote control to the unit operation mode and then use the cursor keys. The following screen appears on the TV when the measurement finishes. Auto Setup Start Exit Measurement Finished Result 3 / 2 / 0.1 ch 3.0 / 10.5 m -3.0 / +10.0 dB OK:ENTER 1 2 3 4 1 The number of speakers (front side/rear side/subwoofer) 2 Speaker distance (nearest/farthest) 3 Adjustment range of speaker output level 4 Warning message (if available) • If any error message (such as E-1) or warning message (such as W-1) appears, see "Error messages" (p.34) or "Warning messages" (p.35). • A speaker with a problem is indicated by blinking of the speaker indicators in the front display. • If multiple warnings are given (when operating with the front display), use the cursor keys (q/w) to check the other warning messages. 6 To save the measurement results, use the cursor keys (e/r) to select "SAVE" and press ENTER. Auto Setup Start Exit SAVE Measurement Finished Result 3 / 2 / 0.1 ch 3.0 / 10.5 m -3.0 / +10.0 dB The adjusted speaker settings are applied. • To finish the measurement without saving the result, select "CANCEL". 7 Disconnect the YPAO microphone from the unit. This completes optimization of the speaker settings. Caution • The YPAO microphone is sensitive to heat, so should not be placed anywhere where it could be exposed to direct sunlight or high temperatures (such as on top of AV equipment). PREPARATIONS ➤ Optimizing the speaker settings automatically (YPAO) En 33