Yamaha RX-V3000 Owner's Manual - Page 36
Exchanging Preset Stations, A-1:FM, E1-A5
View all Yamaha RX-V3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Introduction Preparations AM/FM Tuner MEMORY MAN'L/AUTO FM Shows the displayed station has been programmed to A-1. A-1:FM 89.0 MHz MEMORY STEREO D-TV/LD CABLE SAT VCR 1 VCR2/DVR V-AUX DVD MD/TAPE CD-R TUNER CD PHONO 4 Press MEMORY (MAN'L/AUTO FM). The station band and frequency appear in the display with the preset group and number you selected. 5 Repeat steps 1 through 4 to store other stations. You can store up to 40 stations (A1~A8, B1~B8, C1~C8, D1~D8, and E1~E8). Exchanging Preset Stations PRESET /TUNING EDIT E-1:FM You can exchange the stations stored on two preset numbers. The example below describes the procedure for exchanging the stored stations at preset numbers E1 and A5. 1 Tune to the E1 preset station number. See "Tuning to Preset Stations." 2 Press and hold PRESET/TUNING (EDIT) for more than 3 seconds. "E-1" flashes in the display. PRESET /TUNING EDIT A-5:FM Shows the exchange of stations is completed. EDIT E1-A5 STEREO AUTO D-TV/LD CABLE SAT VCR 1 VCR2/DVR V-AUX DVD MD/TAPE CD-R TUNER CD PHONO 3 Tune to the A5 preset station number. See "Tuning to Preset Stations." A-5 flashes in the display. 4 Press PRESET/TUNING (EDIT) again. The stations stored at the two preset locations are exchanged. Notes: • The memory back-up circuit prevents the stored data from being lost even if this unit is set to standby mode, the power cord is disconnected from the AC outlet, or power service is temporarily cut due to power failure. However, if the power is cut for more than one week, the memory may be deleted. • Any stored station data existing at a preset number is cleared when you store a new station at that preset number. • The reception mode (stereo or monaural) is stored along with the station frequency. Basic Operation Advanced Operation Additional Information Appendix 32