Yamaha RX-V350 Owner's Manual - Page 16

CONNECTIONS Connecting the antennas Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals. AM loop antenna (included) Indoor FM antenna (included) I Connecting the AM loop antenna 1 Set up the AM loop antenna, then connect it to the terminals on this unit. DEO TUNER AM ANT GND 75Ω UNBAL. FM ANT 2 Press and hold the tab to insert the AM loop antenna lead wires into the AM ANT and GND terminals. MONITOR OUT 3 Orient the AM loop antenna for the best Ground (GND terminal) reception. For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth. Notes • The AM loop antenna should be placed away from this unit. • The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit. • A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may improve the quality. Consult the nearest authorized YAMAHA dealer or service center about the outdoor antennas. FREQUENCY STEP switch (Asia and General models only) 100 kHz/10kHz 50 kHz/ 9kHz FM/AM FREQUENCY STEP Because the interstation frequency spacing differs in different areas, set the FREQUENCY STEP switch (locating on the rear panel) according to the frequency spacing in your area. • North, Central and South America: 100 kHz/10 kHz • Other areas: 50 kHz/9 kHz Before setting this switch, disconnect this unit's AC power cord from the wall outlet. 12