Yamaha RX-V392 Owner's Manual - Page 25

English TO PLAY A SOURCE BASIC OPERATIONS 2 3 1, 6 l6 20 28 l2 8 40 4 60 2 0 -dB 47 1 VOLUME l6 20 l2 28 8 40 4 60 2 0 -dB Set to the "∞" position. 2 Turn the power on. POWER 3 Select the desired input source by using the input selector buttons. (For video sources, turn the TV/monitor ON.) TUNER PHONO CD * The name of the selected input source will appear on the display. 4 Select the main speakers to be used. SPEAKERS A B ON OFF * If you use two main speaker systems, press both the A and B switches. 5 Play the source. (For detailed information on the tuning operation, refer to page 26.) 6 VOLUME l6 20 l2 28 8 40 4 60 2 0 -dB Adjust to the desired output level. 7 If desired, adjust the BASS, TREBLE and BALANCE controls (refer to page 25), and use the digital sound field processor. (Refer to page 31.) Notes on using the input selector buttons q Note that pressing on each input selector button selects the source which is connected to the corresponding input terminals on the rear panel. q The selection of TAPE (MD) MONITOR cannot be canceled by pressing another input selector button. To cancel it, press TAPE (MD) MONITOR again so that "TAPE MON" disappears from the display. When you select a button other than TAPE (MD) MONITOR, make sure that "TAPE MON" is not illuminated on the display. q If you select the input selector button for a video source without canceling the selection of TAPE (MD) MONITOR, the playback result will be the video image from the video source and the sound from the audio tape (or MD etc.). q Once you play a video source, its video image will not be interrupted even if the input selector button for an audio source is selected. To turn off the power Press the POWER switch again. 23