Yamaha RX-V430 Owner's Manual - Page 55

INTRODUCTION PREPARATION BASIC OPERATION ADJUSTING THE PARAMETER SETTINGS FOR PRO LOGIC MUSIC Changing parameter settings You can adjust the values of PRO LOGIC Music parameters so the sound fields are recreated accurately in your listening room. Adjustments should be made with the remote control. 1 CODE SET TRANSMIT POWER TV POWER AV STANDBY SYSTEM POWER CD MD/CD-R TUNER SLEEP DVD D-TV/CBL V-AUX 6CH INPUT VCR A B AMP ++ + TV VOL TV CH -- VOLUME - TV MUTE TV INPUT MUTE HALL ROCK ENTER- JAZZ CLUB CONCERT TAINMENT MUTE HALL 1 JAZZ CLUB 2 ROCK CONCERT 3 ENTERTAINMENT 4 TV SPORTS 5 MONO MOVIE 6 MOVIE MOVIE THEATER 1 THEATER 2 7 8 /DTS SUR. 9 SELECT 0 MATRIX 6.1 STEREO +10 ENTER LEVEL TITLE - PRESET/CH SELECT EFFECT SET MENU MENU A/B/C/D/E + TEST RETURN DISPLAY REC DISC SKIP AUDIO 2 3 4 Note • You cannot change parameter values when "10 MEM. GUARD" on the SET MENU is set to ON. Memory back-up The memory back-up circuit prevents the stored data from being lost even if this unit is set in the standby mode, the power cord is disconnected from the AC outlet, or the power supply is temporarily cut due to power failure. However, if the power is cut for more than one week, the parameter value you edited will return to the factory setting. If so, edit the parameter value again. PRO LOGIC Music parameter descriptions 1 Press AMP. AMP 2 Select PRO LOGIC Music. I PANORAMA Function: Choices: Turning the function on extends the front stereo image to include the surround speakers for wraparound effect. OFF/ON, initial setting is OFF. I DIMENSION /DTS SUR. 9 SELECT 0 Function: Gradually adjusts the soundfield either towards the front or towards the rear. Control range: -3 (towards the rear) to +3 (towards the front), initial setting is STD (standard). 3 Press u / d to select the PRESET/CH parameter. I CT WIDTH (Center width) - SELECT + Function: Adjusts the center image from all three front speakers to varying degrees. The larger the value, adjusts the center image towards the main left and right speakers. 4 Press j / i to change the PRESET/CH Control range: 0 (center channel sound is output only from center speaker) to 7 (center channel parameter value. sound is output only from main left and - SELECT + right speakers), initial setting is 3. 5 Repeat steps 3 and 4 above as necessary to change other parameters. ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 51