Yamaha RX-V467 Owners Manual - Page 70
APPENDIX, Troubleshooting, General - remote control
UPC - 027108935867
View all Yamaha RX-V467 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
APPENDIX Troubleshooting Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below, or if the instructions below do not help, turn off this unit, disconnect the power cable, and contact the nearest authorized Yamaha dealer or service center. General Problem The power will not turn on. The unit enters standby mode soon after the power is turned on. This unit cannot be turned off or does not work properly. The unit enters standby mode. Cause Remedy The protection circuitry operated 3 times consecutively. As a safety precaution, when the protection circuitry operates 3 times consecutively, the capability to turn on the power is disabled. Please contact your nearest Yamaha dealer or service center to request repair. The power cable is not completely Connect the power cable properly to an AC inserted. wall outlet. (When this unit is turned back on and "CHECK SP WIRES!" is displayed.) The protection circuitry has been activated because this unit was turned on while a speaker cable was shorted. Make sure that all speaker cables between this unit and speakers are connected properly. The internal microcomputer is hung-up due to an external electric shock (such as lightning or excessive static electricity) or by a drop in power supply voltage. Disconnect the power cable from the AC wall outlet, wait about 30 seconds and then plug it in again. The batteries in the remote control Replace all batteries. may have lost their charge. The protection circuitry has been activated because of a short circuit, etc. Check that the speaker with an impedance of at least 6Ω. (U.S.A. and Canada models) Check that the speaker impedance settings are correct. See page - - 12 - 4 - 12 Problem After display of a countdown on the front panel, the unit goes into standby mode. Sound/images suddenly go off. Cause Remedy If you do not use take any action, the Auto Power Down function operates. Turn on the unit, and play the source again. In the Setup menu "AutoPowerDown" ("Func. Setup" → "AutoPowerDown"), increase the time until switching to standby mode, or turn off the Auto Power Down function. The protection circuitry has been activated because of a short circuit, etc. Check that the speaker wires are not touching each other, then turn the unit back on. The sleep timer has turned off the Turn on the unit, and play the source again. unit. See page - 58 - - En 70