Yamaha RX-V630 Owner's Manual - Page 16

SPEAKER SETUP I IMPEDANCE SELECTOR switch WARNING Do not change setting of the IMPEDANCE SELECTOR switch when the power of this unit is on, this may damage the unit. If this unit fails to turn on when STANDBY/ON (or SYSTEM POWER) is pressed, the IMPEDANCE SELECTOR switch may not be fully slid to either position. If so, slide the switch all the way to either position when this unit is in the standby mode. Select the switch position (left or right) according to the impedance of the speakers in your system. Be sure to move this switch only when this unit is in the standby mode. IMPEDANCE SELECTOR switch MAIN A OR B:4 MIN. /SPEAKER A+B :8 MIN. /SPEAKER CENTER :6 MIN. /SPEAKER REAR CENTER :6 MIN. /SPEAKER REAR :6 MIN. /SPEAKER MAIN A OR B: 8 A+B:16 CENTER : 8 REAR CENTER: 8 REAR :8 MIN. /SPEAKER MIN. /SPEAKER MIN. /SPEAKER MIN. /SPEAKER MIN. /SPEAKER SET BEFORE POWER ON IMPEDANCE SELECTOR SPEAKERS R MAIN L REAR CENTER CENTER + + + A - - - OMPONENT VIDEO R/CR PB/CB Y R R MAIN - B + L R REAR (SURROUND) OUTPUT L REAR CENTER - + L CENTER MAIN A OR B:4 MIN. /SPEAKER A+B :8 MIN. /SPEAKER CENTER :6 MIN. /SPEAKER REAR CENTER :6 MIN. /SPEAKER REAR :6 MIN. /SPEAKER MAIN A OR B: 8 A+B:16 CENTER : 8 REAR CENTER: 8 REAR :8 MIN. /SPEAKER MIN. /SPEAKER MIN. /SPEAKER MIN. /SPEAKER MIN. /SPEAKER R REAR (SURROUND) L SET BEFORE POWER ON IMPEDANCE SELECTOR (U.S.A. model) Switch Speaker position Impedance level Main If you use one set of main speakers, the impedance of each speaker must be 4 Ω or higher. If you use two sets of main speakers, the impedance of each speaker must be 8 Ω or higher. Left Center The impedance must be 6 Ω or higher. Rear The impedance must be 6 Ω or Center higher. Rear The impedance of each speaker must be 6 Ω or higher. Right Main If you use one set of main speakers, the impedance of each speaker must be 8 Ω or higher. If you use two sets of main speakers, the impedance of each speaker must be 16 Ω or higher. [Canada model only] The impedance of each speaker must be 8 Ω or higher. Center The impedance must be 8 Ω or higher. Rear The impedance must be 8 Ω or Center higher. Rear The impedance of each speaker must be 8 Ω or higher. 12