Yamaha RX-V870 Owner's Manual - Page 13
Remote Control Transmitter, Speaker Configuration, Normal, Phantom, Illustrations: Rx-v1070 - display
View all Yamaha RX-V870 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
7 10 9 8 7 10 Illustrations: RX-V1070 Parts in shaded areas ( ) are not present on RX-V870. For detailed information on the remote control transmitter, refer to "REMOTE CONTROL TRANSMITTER" on page 25. 7 ou 8 Select the center mode according to your speaker configuration. (Refer to "SPEAKER CONFIGURATION" on page 6.) 10 Turn up the volume by using the remote control transmitter. You will hear a test tone (like pink noise) from the left front speaker, then the center speaker, then the right front speaker, and then the rear speakers, for about two seconds each. The display changes as shown below. Front (L) Center CENTER MODE NORMAL WIDE PHANTOM On the feature of each mode, refer to the "Note" shown below. 9 NORMAL Flashes continuously. Rear Front (R) (L and R) * If your monitor is on, the state of test tone output is also shown by an image of audio listening room on the monitor's screen. * The test tone from the left rear speaker and the right rear speaker will be heard at the same time. Note In step 8, when you select the center mode, note the following. For 5 speaker configuration) NORMAL: Select this mode when you use a center speaker that is smaller than the front speakers. In this mode, the bass tone will be output from the front speakers. WIDE: Select this mode when you use the center speaker approximately same sized as the front speakers. For 4 speaker configuration) PHANTOM: Select this mode when you do not use the center speaker. The center sound will be output from the left and right front speakers. 13