Yamaha Rio1608-D Rio3224-D/Rio1608-D Owners Manual [English] - Page 18
Warning Messages, Information Messages
View all Yamaha Rio1608-D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Troubleshooting Warning Messages The indicators will light and/or flash as shown until the cause is resolved. If the green [SYNC] indicator is unlit, the unit's clock is unconfirmed. SYNC Indicators Description The word clock is not set correctly. Flash Dante Network circuit is broken. Flash x2 Possible Solution Set the clock master and sampling frequency correctly on the Rio-native device or in Dante Controller. Make sure that the Ethernet cables are not removed or short-circuited. Flash x3 Other Dante-compatible devices cannot be found due to an incorrectly-wired Dante Network. Make sure that the Ethernet cables are connected correctly. If the green indicator is flashing, the unit is the clock master. If the green indicator is lit, the unit is the clock slave and the clock is synchronized. SYNC Indicators Description Possible Solution A non-GbE-compatible device is connected. When transferring audio via Dante, use device that supports GbE. Light or flash Light Light or flash Flash The [SECONDARY] connector has taken over communications during redundant network operation. Check the circuit connected to the [PRIMARY] connector. Light or flash Flash x2 An abnormality has occurred on the circuit connected to the [SECONDARY] connector during redundant network operation. Check the circuit connected to the [SECONDARY] connector. Information Messages The indicators will remain lit and/or flashing cyclically to report the status. If the orange [SYNC] indicator is unlit, the unit is operating normally. If the green [SYNC] indicator is unlit, the unit's clock is unconfirmed. SYNC Indicators Description Synchronizing on a Dante network Light Waiting to receive setting data The unit is functioning correctly as the word clock master. Explanation Please wait until started has completed or until the unit has finished synchronization. It may take up to 45 seconds for completion. If START UP MODE is set to REFRESH on the R-series unit, the input/output will be muted until the unit receives setting data after it starts up. The unit is operating as the word clock master. Flash Light The unit is functioning correctly as the word clock slave. The unit is operating as the clock slave and the clock is synchronized. 18 Owner's Manual