Yamaha Ro8-D Ri8-D/Ro8-D Firmware Update Guide V3.10 or older - Page 7

■ Updating the Ri/Ro firmware This section explains how to update the Ri/Ro firmware. Before you start updating the firmware, decompress the downloaded compressed file. Place "RI8RO8_PROG.bin," "updatev2.exe" and "update.ini in the same folder. For information about messages displayed by the Ri/Ro firmware update program, refer to "Error Message List (R Series Update Program V2)" at the end of this guide. ・ Before starting the update program, quit all other programs. While the update is in progress, do not start any other programs or switch between windows. ・ If your computer enters Sleep or Energy Save mode, data transfer to the device may stop. Therefore, you should disable these functions to prevent this from happening. We also recommend that you do not use any screen saver or similar background programs. 1. Turn off the power to the Ri/Ro. 2. Take note of the dip switch settings on the Ri/Ro unit front panel. Follow the procedure below to change dip switch settings. Take note of the original dip switch settings in order to restore the settings when the Dante firmware update is completed. 3. Disconnect the Ethernet cable from the Dante [PRIMARY] connector and [SECONDARY] connector on the rear panel of the Ri/Ro unit. 4. Pull the dip switch 4 on the Ri/Ro unit front panel down (ON) and turn the power on with the other switches remaining in their up positions (OFF). 5. After the orange [SYNC] indicator flashes twice periodically on the front panel of the Ri/Ro unit, turn off the power. 6. Connect the Dante [PRIMARY] connector on the rear panel of the Ri/Ro unit to the Ethernet connector on the computer using an Ethernet cable. 7