Yamaha SPX2000 SPX2000 Owners Manual - Page 9
Rear panel - 21
View all Yamaha SPX2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Rear panel R S T UVW X Y [ Q Z \ Q Grounding screw For safety, use this screw to ground the SPX2000. The included power cable has a three-prong plug; if the electrical outlet you use is correctly grounded, the SPX2000 will be appropriately grounded. If the electrical outlet is not grounded, use this screw to ground the SPX2000. Correctly grounding the SPX2000 will effectively reduce hum and interference. R [AC IN] jack Connect the power cable to this jack. First connect the power cable to the SPX2000, and then connect the other end to the electrical outlet. Use only the supplied power cord. S [MIDI OUT/THRU] connector You can connect a MIDI device to this connector and use MIDI messages to send SPX2000 data to it. You can bulk-dump SPX2000 data via MIDI, or re-transmit MIDI data received at the [MIDI IN] connector (T) from this connector without change. Use "MIDI OUT SETUP" (page 21) to specify whether this connector functions as "MIDI OUT" or "MIDI THRU." T [MIDI IN] connector You can connect a MIDI device to this connector and use messages transmitted from that device to remotely control the SPX2000 (page 88). U [TO HOST USB] connector You can use a USB cable to connect your computer here. You can use SPX2000 Editor or your MIDI application to remotely control the SPX2000 from your computer (page 6). V [WORD CLOCK IN] jack Connect this jack to a device that supplies a word clock signal. This jack is terminated with a 75-ohm resistor. Connect this jack in a one-to-one connection with the device supplying the word clock. W [AES/EBU OUT] jack Connect an AES/EBU format device to this jack. This XLR-3-32 jack outputs an AES/EBU format digital signal. X [AES/EBU IN] jack Connect an AES/EBU format device to this jack. This XLR-3-31 jack inputs an AES/EBU format digital signal. Y [OUTPUT] jacks Connect these jacks to the effect return of your mixer or to the input of your power amp. These jacks output analog signals. Use either the XLR-3-32 jacks or the TRS phone jacks, as appropriate for the device you are connecting. Z [OUTPUT -10 dBu/+4 dBu] switch Set this to either -10 dBu or +4 dBu according to the input level of the device connected to the [OUTPUT] jacks (Y). [ [INPUT] jacks Connect these jacks to the effect send of your mixer or to the output of an electronic musical instrument. These jacks input analog signals. Use either the XLR-331 jacks or the TRS phone jacks, as appropriate for the device you are connecting. In order to enable these jacks, you must set the input source setting to "ANALOG" (page 19). \ [INPUT -10 dBu/+4 dBu] switch Set this to either -10 dBu or +4 dBu according to the output level of the device connected to the [INPUT] jacks ([). SPX2000-Owner's Manual 9