Yamaha SRT-700 Owners Manual - Page 14

Settings Programming the unit with the TV's remote control (TV's remote control learning function) Once you program the unit, you can control it with your TV's remote control for functions such as turning on/off the TV and unit simultaneously, or volume up/down and muting/ unmuting of the unit. • This function is available only when your TV's remote control uses IR (infrared) signal. • A radio wave remote control will not work. • If by changing the volume of the unit the TV's volume also changes, set the TV's volume to minimum, or disable speaker output. 1 Turn off the TV. 2 Turn off the unit. 3 Hold down the LEARN key on the unit's remote control for more than 3 seconds to set the unit to the learning mode. When the unit is in the learning mode, the indicators on the front panel flash as shown below. NOTE • Steps 4 to 7 require only the TV's remote control and the keys on the front panel of the unit. The remote control of the unit is not necessary. • If the unit has already learned functions, the following indicators light up. Mute: TV Volume (-): BD/DVD Volume (+): ANALOG Power: BLUETOOTH 4 Teach the unit the "Mute" code of the TV's remote control. 4-1 Press MUTE on the front panel of the unit. 4-2 While pointing your TV's remote control at the remote control sensor, hold down the mute key for more than 1 second twice or three times. Approx. 30 cm (1 ft) TV's remote control Hold down Release Hold down (more than 1 second) (more than 1 second) (more than 1 second) Result Bleep/buzzer Indicators Successfully learned Once Lights up Failed to learn * Repeat from Twice Step 4-1. Flash Release (...) For cable or satellite set top box users: Use the original TV's IR remote control (not the cable or satellite set top box's remote control) to program the unit. 12 En