Yamaha TX-480 Owner's Manual - Page 3
Caution, Supplied Accessories, Fcc Information U.s.a. - user manual
View all Yamaha TX-480 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
CAUTION: READ THIS BEFORE OPERATING YOUR UNIT 1. This unit is a sophisticated AM/FM stereo tuner. To assure proper operation and the best possible performance, please read this manual carefully. 2. Choose the installation location for the unit carefully. Avoid placing it in direct sunlight or close to a source of heat. Also avoid locations subject to vibration and excessive dust, heat, cold or moisture. Keep it away from such sources of hum as transformers or motors. 3. Do not open the cabinet, because this may result in damage to the unit or electrical shock. If a foreign object should get into the unit, contact your local dealer. 4. To prevent lightning damage, disconnect the AC power plug and disconnect the antenna cable when there is an electrical storm. 5. When disconnecting the power plug from the wall outlet, always pull directly on the plug; never pull the cord itself. 6. Do not use force when operating switches and other controls. 7. When moving the unit, be sure to first disconnect the power plug and disconnect all wires connected from the unit to other equipment. 8. Do not attempt to clean this unit with chemical solvents, because this may damage the finish. Use a clean, dry cloth. 9. Be sure to read the "TROUBLESHOOTING" section of this manual for advice on common operating errors before concluding that the unit is faulty. 10. Keep this manual in a safe place for future reference. FCC INFORMATION (U.S.A.) 1. IMPORTANT NOTICE : DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. 2. IMPORTANT : When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST be used. Follow all installation instructions. Failure to follow instructions could void your FCC authorization to use this product in the USA. 3. NOTE : This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class "B" digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may cause interference harmful to the operation of other electronic devices. Compliance with FCC regulations does not guarantee that interference will not occur in all installations. If this product is found to be the source of interference, which can be determined by turning the unit "OFF" and "ON", please try to eliminate the problem by using one of the following measures: Relocate either this product or the device that is being affected by the interference. Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s. In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to coaxial type cable. If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Electronics Corp., U.S.A. 6660 Orangethorpe Ave, Buena Park, CA 90620. The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries. SUPPLIED ACCESSORIES After unpacking, check that the following parts are contained. AM Loop Antenna Indoor FM Antenna Audio connection cord 3