Yamaha TX5n Owner's Manual - Page 11

Audio I/O Settings The TXn can be operated in one of three audio input/output modes: Stereo mode, Parallel mode, or Bridge mode. Make audio input/output connections and settings as follows. NOTE • With the factory settings, if both analog and digital (input from the slot) signals are input simultaneously, the two signal will be mixed and output. This setting can be changed from the panel of the TXn or via Amp Editor. For details on making this setting, refer to "TX6n/5n/4n Reference Manual" or "Amp Editor Owner's Manual." • Use 110-ohm AES/EBU digital cables for digital audio connections. Using analog cables may degrade the sonic quality. Stereo Mode Channels A and B (analog) or channels 1 and 2 (digital) will operate independently in stereo. 5-way binding post connectors Parallel Mode The amplifier will operate as a two-channel monaural amp, with the input signal of channel A (analog) or channel 1 (digital) as the source. Channel B (analog) and channel 2 (digital) will not be used. 5-way binding post connectors - - ++ Total speaker Total speaker impedance: impedance: 2-8Ω 2-8Ω Digital input Analog input Speakon connectors - - ++ Total speaker Total speaker impedance: impedance: 2-8Ω 2-8Ω Digital input Speakon connectors Analog input Total speaker Total speaker impedance: impedance: 2-8Ω 2-8Ω Digital input Analog input NOTE • Each of 5-way binding post connectors and Speakon connectors are internally parallel-connected. When using both connectors simultaneously, total speaker impedance of each connector must be 4-16 Ω. Total speaker Total speaker impedance: impedance: 2-8Ω 2-8Ω Digital input Analog input NOTE • Each of 5-way binding post connectors and Speakon connectors are internally parallel-connected. When using both connectors simultaneously, total speaker impedance of each connector must be 4-16 Ω. TX6n/5n/4n Owner's Manual 11