Yamaha V2.0 V2.0 Supplement - Page 5
Clearing the A, B, IN & OUT Points, Using the A, IN & OUT Points as Edit Times
View all Yamaha V2.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
5 Clearing the A, B, IN & OUT Points Previously set A, B, LAST REC IN and OUT points can now be cleared. 1 While holding down the [CANCEL] button, press the [A], [B], [IN], or [OUT] button. The previously set point is cleared and the corresponding indicator goes out. So long as the loaded disk is not write-protected, the A, B, LAST REC IN and OUT point information stored on disk is also cleared. This new function also works on the remote controller. Using the A, B, IN & OUT Points as Edit Times The A, B, LAST REC IN and OUT points can now easily be used as the start (ST) and end (ED) times when using a part edit function, the Time Compression function, or the Pitch Change function. 1 When the display shows "ST xxxxxxxx" or "ED xxxxxxxx" or "TO xxxxxxxx" and you are required to enter a start, end, or to time, press the [A], [B], [IN], or [OUT] button. The time value previously stored for that point is entered and appears on the display. If no point has been set, no time value is entered. Using the Solo Buttons to Select Tracks The SOLO/SELECT buttons can now be used to select the source and destination tracks for the track and part editing functions and the Time Compression and Pitch Change functions. (Previously, only the JOG/DATA dial could be used to select tracks.) 1 When the display shows "FROM TR" or "TO TR," use the SOLO/SELECT buttons to select the source or destination tracks. As with the JOG/DATA dial, depending on the function being used, tracks can be selected individually (1-8) or in pairs (1/2, 3/4, 5/6, 7/8). Note that the JOG/DATA dial must be used to select destination virtual tracks. Remaining Time The time remaining can now be checked while recording is in progress. (Previously, it could be checked only when the D24 had stopped.) Apogee I/O Cards The D24 now supports the Apogee AP8AD and AP8DA mini YGDAI I/O cards. (Only the AP8AD is currently available.) D24-Version 2.0 Supplement