Yamaha V2.5 RIVAGE PM series V2.5 Supplemental Manual EN - Page 9

Dante Domain Manager (DDM)  REMOTE Indicates the access status of the Dante settings of the external Dante device. • Operator: The settings can be both read and written. • Guest: The settings can only be read, but not written. • None: The settings cannot be read.  LATENCY field Indicates the currently-selected latency. If the unit is off-line, the field will indicate "----".  SYNC TO EXTERNAL button If this button is turned on, the unit will synchronize with the word clock supplied from the HY slot. Screen variation Part of the following screens will vary depending on the REMOTE setting. DANTE I/O DEVICE [I/O] screen SYSTEM CONFIG popup window CONTENTS ■ Supplemental information regarding the DSP mirroring operation on the Dante audio network If the primary (active) DSP engine fails, the secondary (standby) DSP engine will automatically take over all input/output patches for the TWINLANe network, and the audio will continue seamlessly. However, the secondary DSP engine will not take over the patches for the Dante audio network. Consequently, you need to configure these patches separately. Configure input patches in advance to the Dante cards (HY144-D, HY144-D-SRC) installed in HY SLOT3 on both active and standby DSP engines. Assign a unique control ID to active and standby DSP engines. In addition, apply the same With Recall settings to both DSP engines. Configure output patches from the Dante cards (HY144-D, HY144-D-SRC, Dante MY16-AUD card) that are installed on the RPio622/222. These settings will prevent audio input/output and HA control from being interrupted even when a failover occurs, and the audio will continue seamlessly. Please note that the Dante patches for the Dante card (HY144-D, HY144-D-SRC) inserted in the standby DSP engine cannot be configured in advance. Prepare a Dante preset separately and switch it over manually after a failover occurs. Also, HA control is possible only from a Dante card (HY144-D, HY144-D-SRC) installed in HY SLOT 3 on the DSP engine. RPio M1 HY-256TL HY144-D/ HY144-D-SRC Dante MY16-AUD2 Dante MY16-AUD2 DSP 1A HY-256TL ID # 1 HY144-D/ HY144-D-SRC DSP 1B HY-256TL ID # 2 HY144-D/ HY144-D-SRC Network Switch Rio ID 001 Rio ID 002 Rio ID 003 9 RIVAGE PM series V2.5 Supplemental Manual