Yamaha YDP-103 YDP-103 Owners Manual - Page 22
Keyboard Stand Assembly
View all Yamaha YDP-103 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Keyboard Stand Assembly CAUTION • Be careful not to confuse parts, and be sure to install all parts in the correct orientation. Please assemble the unit in accordance with the sequence given below. • Assembly should be carried out by at least two persons. • Assemble the unit on a hard and flat floor with ample space. • Be sure to use the included screws only, and insert screws of the correct size in the correct hole locations. Use of incorrect screws can cause damage or malfunction of the product. • Be sure to tighten all screws upon completing assembly of the unit. • To disassemble, reverse the assembly sequence given below. Have a Phillips-head (+) screwdriver of the appropriate size ready. 1. After untying the bundled pedal cord on C, attach C to D and E and fasten the screws (1-3). E 1-2 D C Remove all parts from the package and make sure you have all of the items. Cord holder A D E B C Bundled pedal cord inside AC adaptor * The adaptor may not be included, or may look different from the illustration above, depending on your particular area. Please check with your Yamaha dealer. Screws set 6 x 20 mm long screws x 4 4 x 12 mm thin screws x 2 6 x 16 mm short screws x 4 4 x 20 mm tapping screws x 4 22 YDP-103 Owner's Manual 1-3 1-1 1-1 Untie and straighten out the bundled pedal cord. Untie the two vinyl strings. C 1-2 Align D and E with each end of C. 1-3 Attach D and E to C by finger-tightening the long screws (6 x 20 mm). 2. Attach B. Depending on the model of digital piano you purchased, the surface color of one side of B may be different from the other side. In this case, position B so that the side of the surface color similar to D and E faces the player. 2-1 Place the lower side of B on each foot of D and E, then attach the upper side to D and E. 2-2 Attach the top of B to D and E by finger- tightening the thin screws (4 x 12 mm). 2-3 While pressing on the lower part of D and E from the outside, secure the bottom ends of B using two tapping screws (4 x 20 mm). 2-4 Insert the other two tapping screws (4 x 20 mm) into the other two screw holes to secure B.