Yamaha YDP-181 Owner's Manual - Page 49
Control Change ON/OFF, Panel/Status Transmit, Procedure, F6.7: Initial Setup Send, Setting range
View all Yamaha YDP-181 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
ENGLISH Control Change ON/OFF Normally the instrument will respond to MIDI control change data received from an external MIDI device or keyboard, causing the voice on the corresponding channel to be affected by pedal and other "control" settings received from the controlling device (the keyboard voice is not affected). The instrument also transmits MIDI control change information when the pedal or other appropriate controls are operated. This function makes it possible to cancel control change data reception and transmission so that, for example, the instrument's pedal and other controls can be operated without affecting an external MIDI device. NOTE For information on control changes that can be used with the instrument, refer to the MIDI Data Format in our manual library at the following website. http://www.yamaha.co.jp/manual/ Setting range: ON/OFF Normal setting: ON F7.6 Panel/Status Transmit This function causes all the current instrument panel settings (selected voice, etc.) to be transmitted via the MIDI OUT terminal. TERMINOLOGY Setup Data: Data that contains a set of panel settings for the instrument. Procedure 1. Set up the panel controls as desired. 2. Connect the instrument to a sequencer via MIDI, and set up the sequencer so it can receive the setup data. 3. Engage the Function mode and select . 4. Press the [+/YES] button to transmit the panel/status data. will appear on the LED display when the data has been successfully transmitted. NOTE For a list of the "Panel Data Contents" transmitted by this function, refer to our manual library at the following website. http://www.yamaha.co.jp/manual/ NOTE Receiving the transmitted data: 1. Connect the instrument via MIDI to the device to which the setup data was transmitted previously. 2. Start sending the setup data from the device. The instrument automatically receives the setup data, which will be reflected in the panel settings. (For the data to be accepted, the instrument that receives the setup data should be the same model as the one that transmitted the setup data to the sequencer.) Detailed Settings - [FUNCTION] NOTE For more information on transmitting and receiving setup data via MIDI, refer to the owner's manual for the connected MIDI device. F6.7: Initial Setup Send This function lets you send the data of the panel settings to a computer. By transmitting the panel settings and recording them on the MIDI sequence recorder prior to the actual performance data, the instrument will be automatically restored to the same settings when the performance is played back. You can also use this function to change the settings of a connected tone generator to the same settings as the instrument. Procedure 1. Set up the panel controls as desired. 2. Connect the instrument to a sequencer via MIDI, and set up the sequencer so it can receive the setup data. 3. Engage the Function mode and select . 4. Press the [+/YES] button to transmit the panel/status data. will appear on the LED display when the data has been successfully transmitted. The following data can be sent. • Voice selection • [REVERB] type • [REVERB] depth • [EFFECT] type • [EFFECT] depth • Tuning (F1) • Dual detune (F3.2) Owner's Manual 49