Yamaha YHT-24 Quick Connect Guide - Page 11
Rogramming, Niversal, Emote, Ontrol, Ontinued
View all Yamaha YHT-24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
YHT-24 QUICK-CON N ECT GUIDE PROGRAMMING THE UNIVERSAL REMOTE CONTROL (CONTINUED) SETTING UP YOUR CABLE BOX (OR DSS) 1. Turn on the cable box (or DSS) and look up a setup code for your brand of cable box (or DSS) (codes are located at the back of the HTR-5440 Owner's Manual. 2. On the remote control, press CBL/SAT. 3. Press and hold both VOLUME buttons at least four seconds until the indicator LED flashes twice. 4. Using the keypad, enter the four-digit setup code. The indicator LED will flash twice after your entry. If the LED did not flash twice, repeat steps 3 and 4. 5. To verify the code works, aim the remote control at the cable box (or DSS), press CBL/SAT, and then press POWER. The unit should turn off. If it doesn't respond, use another code for the same manufacturer and repeat steps 3 through 5. SETTING UP YOUR VCR 1. Turn on the VCR and look up a setup code for your brand of VCR. 2. On the remote control, press VCR. SETTING UP OTHER COMPONENTS 1. Turn on the component (e.g., CD player, tape deck, or MD player) and look up a setup code for your brand of component. 2. On the remote control, press the desired component button (e.g., CD or TAPE/MD). 3. Press and hold both VOLUME buttons at least four seconds until the indicator LED flashes twice. 4. Using the keypad, enter the four-digit setup code. The indicator LED will flash twice after your entry. If the LED did not flash twice, repeat steps 3 and 4. 5. To verify the code works, aim the remote control at the component, press the appropiate component button, and then press POWER. The unit should turn off. If it doesn't respond, use another code for the same manufacturer and repeat steps 3 through 5. 3. Press and hold both VOLUME buttons at least four seconds until the indicator LED flashes twice. 4. Using the keypad, enter the four-digit setup code. The indicator LED will flash twice after your entry. If the LED did not flash twice, repeat steps 3 and 4. 5. To verify the code works, aim the remote control at the VCR, press VCR, and then press POWER. The VCR should turn off. If it doesn't respond, use another code for the same manufacturer and repeat steps 3 through 5. 11