Yamaha YSP-5100BL Owners Manual - Page 17
Bauto Setup, Auto Setup, Auto Setup Start, Show Result
View all Yamaha YSP-5100BL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
INTRODUCTION PREPARATION PLAYBACK FEATURES p p 2 Press G / to select "AUTO SETUP" and then press GENTER. B)AUTO SETUP 1)BEAM+SOUND OPTIMZ 2)BEAM OPTIMZ ONLY 3)SOUND OPTIMZ ONLY [ ]/[ ]:Up/Down [ENTER]:Enter 3 Press G / to select "BEAM+SOUND OPTIMZ", "BEAM OPTIMZ ONLY" or "SOUND OPTIMZ ONLY" and then press GENTER. AUTO SETUP PREPARATION & CHECK Please connect the MIC. Please place the MIC at least 1.8m/6ft away from the unit. The MIC should be set at ear level when seated. Measurement takes about 3min. After [ENTER] is pressed, please leave the room. [ENTER]:Start [RETURN]:Cancel y • If "ENVIRONMENT CHECK [FAILED]" is displayed, refer to "Error messages for AUTO SETUP" (page 18), press IRETURN, and then run the AUTO SETUP procedure again. • If "SUBWOOFER :NOT APPLICABLE" is displayed even though a subwoofer is connected to this unit and turned on, check the connection and then increase the volume level of the subwoofer and run the AUTO SETUP procedure again. • Depending on the environment of your listening room, the beam angles of front right and left and surround left and right may be set to the same value even if "BEAM MODE :5 BEAM" is displayed as a result. 6 Press GENTER to confirm the results. The menu screen disappears in two seconds. AUTO SETUP COMPLETE Please remove the MIC from the unit and the listening position. 4 Prepare to leave the room. The best setting may not be done if you are in the room. Prepare to leave the room in 10 seconds after pressing GENTER in step 5. y • Wait outside the room during the AUTO SETUP procedure. • The AUTO SETUP procedure takes about 3 minutes. • To cancel the AUTO SETUP procedure after it is started, press IRETURN. 5 Press GENTER to start the AUTO SETUP procedure and then leave the room within 10 seconds. AUTO SETUP START Will begin in 10sec Please leave the room **-------[RETURN]:Cancel y • If you do not want to reflect the results, press IRETURN. 7 Disconnect the IntelliBeam microphone. INPUT VOLUME INTELLIBEAM MIC The measurement results are stored in the internal memory of this unit until you run the AUTO SETUP procedure again or configure the settings manually. Changing OSD language AUTO SETUP (IntelliBeam) Using the system memory The setup screen automatically changes during the AUTO SETUP procedure. If an error occurs, an error buzzer sounds and an error message is displayed. For details on error messages, see "Error messages for AUTO SETUP" (page 18). If the AUTO SETUP procedure is complete, this unit rings the chimes. XXXXXXXXSHOW RESULTXXXXXXXXXX MEASUREMENT COMPLETE BEAM MODE :5Beam/Plus2 SUBWOOFER :YES [ENTER]:Save set-up. [RETURN]:Do not save set-up. SETTINGS APPENDIX 17 En