Yamaha YSP-5100BL Owners Manual - Page 45

INTRODUCTION PREPARATION PLAYBACK FEATURES Status message ACQUIRING UPDATE FW UPDATING SUB UPDATED Cause Remedy The signal is too weak. The SiriusConnect tuner is updating the channel list. The period of the subscription is end. The SiriusConnect tuner is updating the firmware. The subscription information is updated. Adjust the orientation of the antenna of the SiriusConnect tuner. Use the "Antenna Level" information on the front panel display to check the antenna reception level. Wait until the updating is complete. Contact SIRIUS Satellite Radio to renew the subscription. Wait until the updating is complete. - See page - - 27 - - ■ Remote control Problem Cause Remedy The remote control does not work and/or function properly. Cannot operate external components with the remote control of this unit. Wrong distance or angle. The remote control functions within a maximum range of 6 m (20 ft) and no more than 30 degrees offaxis from the front panel. Direct sunlight or lighting (from an inverter type of fluorescent lamp, etc.) is striking the remote control sensor of this unit. Reposition this unit. The batteries are weak. Replace all batteries. The external component you want to operate is not selected as the input source. Press the desired DInput selector key to select the external component you want to operate. The remote control code was not correctly set. Set the remote control code correctly or try another code for the same manufacturer using the "List of remote control codes". Even if the remote control code is correctly set, there are some models that do not respond to the remote control. Use the remote control supplied with the external component. See page 14 - 14 42 42 - ■ iPod Problem Cause Remedy No sound. Controlling volume on the iPod or iPhone does not work. PDX-50TX is connected to another device. Select the same group ID as selected on this unit. PDX-50TX and this unit are not connected since they Set both PDX-50TX and this unit to the same group. are set to different groups. "Wireless Function" is set to "No". Set "Wireless Function" to "Yes". Distance is too far. Move PDX-50TX closer to this unit. There is a device (microwave oven, wireless LAN, etc.) outputting signals in 2.4 GHz frequency band nearby. Move this unit away from the device. If the device is IEEE802.11n-compliant, change the channel setting of the device so as not to affect the unit. The iPod or iPhone is not connected to PDX-50TX Connect the iPod or iPhone firmly. firmly. The firmware of the iPod or iPhone is not updated. Download the latest iTunes software to update the firmware of the iPod or iPhone. The signal from PDX-50TX is blocked by your body Change the way of holding, orientation, or position of or metallic objects, etc. PDX-50TX to avoid the object blocking the signal. The battery of iPod or iPhone is low. Charge the iPod or iPhone. The iPod or iPhone is in the process of connecting with this unit. Please wait for a while. The protection circuitry has been activated by excessive volume. Turn down the volume. The iPod or iPhone being used is not supported by this unit. Use an iPod or iPhone supported by this unit. The iPod or iPhone is not connected to PDX-50TX Connect the iPod or iPhone firmly. firmly. See page - 39 39 - - - - - - - 21 30 - SETTINGS APPENDIX 45 En