Zanussi ZBA22420SA Product Manaul - Page 7
Periods of non-operation
View all Zanussi ZBA22420SA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
7. Reload the previously removed food into the compartment. Important! Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. Periods of non-operation When the appliance is not in use for long periods, take the following precautions: What to do if... • disconnect the appliance from electricity supply • remove all food • defrost (if foreseen) and clean the appliance and all accessories • leave the door/doors ajar to prevent unpleasant smells. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. Warning! Before troubleshooting, disconnect the mains plug from the mains socket. Only a qualified electrician or competent person must do the troubleshooting that is not in this manual. Important! There are some sounds during normal use (compressor, refrigerant circulation). Problem The appliance does not operate. The lamp does not operate. The lamp does not work. The compressor operates continually. Water flows on the rear plate of the refrigerator. Water flows into the refrigerator. Possible cause The appliance is switched off. The mains plug is not connected to the mains socket correctly. The appliance has no power. There is no voltage in the mains socket. The lamp is in stand-by. The lamp is defective. The temperature is not set correctly. The door is not closed correctly. The door has been opened too frequently. The product temperature is too high. The room temperature is too high. During the automatic defrosting process, frost defrosts on the rear plate. The water outlet is clogged. Products prevent that water flows into the water collector. Solution Switch on the appliance. Connect the mains plug to the mains socket correctly. Connect a different electrical appliance to the mains socket. Contact a qualified electrician. Close and open the door. Refer to "Replacing the lamp". Set a higher temperature. Refer to "Closing the door". Do not keep the door open longer than necessary. Let the product temperature decrease to room temperature before storage. Decrease the room temperature. This is correct. Clean the water outlet. Make sure that products do not touch the rear plate. www.zanussi.com 7