Zanussi ZBA22420SA Product Manaul - Page 8
Replacing the lamp, Closing the door
View all Zanussi ZBA22420SA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Problem Water flows on the ground. The temperature in the appliance is too low. The temperature in the appliance is too high. Possible cause The melting water outlet does not flow in the evaporative tray above the compressor. The temperature regulator is not set correctly. The temperature regulator is not set correctly. The door is not closed correctly. The product temperature is too high. Many products are stored at the same time. There is no cold air circulation in the appliance. Solution Attach the melting water outlet to the evaporative tray. Set a higher temperature. Set a lower temperature. Refer to "Closing the door". Let the product temperature decrease to room temperature before storage. Store less products at the same time. Make sure that there is cold air circulation in the appliance. Replacing the lamp Caution! Disconnect the plug from the mains socket. Remove the screw from the lamp cover. Remove the lamp cover (refer to the illustration). Replace the used lamp with a new lamp of the same power and specifically designed for household appliances (the maximum power is shown on the lamp cover). Install the lamp cover. Tighten the screw to the lamp cover. Connect the plug to the mains socket. Open the door. Make sure that the light comes on. Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Service Center. 8 www.zanussi.com