Zanussi ZCG43250WA User Manual - Page 8
Before First Use, Hob - Daily Use
View all Zanussi ZCG43250WA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
BEFORE FIRST USE WARNING! Refer to Safety chapters. INITIAL CLEANING Remove all accessories and removable shelf supports from the oven. Refer to "Care and cleaning" chapter. Clean the oven and the accessories before the first use. Put the accessories and the removable shelf supports back to their initial position. SETTING AND CHANGING THE TIME You must set the time before you operate the oven. When you connect the appliance to the electrical supply or after a power cut, flashes. Press the or to set the correct time. HOB - DAILY USE After approximately 5 seconds, the flashing stops and the display shows the time of day. To change the time, press again and again until starts to flash. PREHEATING Preheat the empty appliance before first use. Preheat the two ovens. Heat up one oven at a time. 1. Set the maximum temperature. 2. Let the appliance operate for 1 hour. 3. Set the function . 4. Let the appliance operate for 15 minutes. Accessories can become hotter than usual. The appliance can emit an odour and smoke. This is normal. Make sure that the airflow is sufficient. WARNING! Refer to Safety chapters. IGNITION OF THE HOB BURNERS Always light the burner before you put on the cookware. WARNING! Be very careful when you use open fire in the kitchen environment. The manufacturer declines any responsibility in case of the flame misuse. 1. Turn the knob for the hob to the position and push it down. When you push the knob, the spark generator activates automatically. 2. Keep the knob for the hob pushed for equal or less than 10 seconds to let the thermocouple warm up. If not, the gas supply is interrupted. 3. Adjust the flame after it is regular. WARNING! Do not keep the knob pushed for more than 10 seconds. If the burner does not light after 10 seconds, release the knob, turn it into the off position and try to light the burner again after minimum 1 minute. If after some tries the burner does not light, check if the crown and its cap are in the correct position. In the absence of electricity you can ignite the burner without an electrical device. In this case approach the burner with a flame, push the relevant knob down and turn it to maximum position. Keep the knob pushed for equal or less than 10 seconds to let the thermocouple warm up. If the burner accidentally goes out, turn the knob to the off position and try to light the burner again after minimum 1 minute. The spark generator can start automatically when you switch on the mains, after installation or a power cut. It is normal. 8