Zanussi ZDC37200W Product Manaul - Page 10

Drying cycle complete / removing laundry Once the drying cycle is complete, the LED Anti-crease/End is on as well as warning LED's: Filter and Tank. If the Buzzer button has been pressed, an acoustic signal sounds intermittently for about one minute. Remove the laundry: 1. Open door. 2. Remove visible fluff from the fluff filters. It is best to use a damp hand for this purpose. (see chapter: Maintenance and cleaning) 3. Remove laundry. 4. Turn the programme selector to off. Cleaning and maintenance Important! after each drying cycle: - clean the fluff filters - drain the water reservoir (see chapter: Maintenance and cleaning) 5. Close the door. The drying cycles are automatically followed by an anti-crease phase which lasts around 30 minutes. The drum rotates at intervals during this phase to protect the laundry from creases. The laundry can be removed at any time during the anti-crease phase. Cleaning fluff filters The filters collect all the fluff which accumulates during drying. To ensure that the dryer works perfectly, the fluff filters (fine filters and fluff filters) must be cleaned after each drying cycle. Caution! Never operate the dryer without fluff filters or with damaged or blocked fluff filters. Clean the door seal Wipe the door seal with a damp cloth immediately after the drying cycle has finished. Emptying the water reservoir Empty the water reservoir after every drying cycle. I II 1 I 2 3 4 5 6 7 II Caution! The condensed water is not suitable for drinking or for preparing foodstuffs. If the programme has been interrupted as a result of the water reservoir being full: Press the Start/Pause button to continue the drying cycle. 10 www.zanussi.com