Zanussi ZKG7165 Product Manaul - Page 17

Important! • The selected delay can be changed only af- ter selecting the washing programme again. • The door will be locked throughout the delay time. If you need to open the door, you must first set the washing machine to PAUSE by pressing button 7 and wait a few minutes before opening the door. After you have closed the door, press the same button again. Important! The Delay Start cannot be selected with the draining programme. Altering an option or a running programme It is possible to change some options before the programme carries them out. Before you make any change, you must pause the washing machine by pressing button 7. Changing a running programme is possible only by resetting it. Turn the programme selector dial to and then to the new programme position. Start the new programme by pressing button 7 again. The washing water in the tub will be not emptied out. Interrupting a programme Press the button 7 to interrupt a programme which is running, the corresponding pilot light starts blinking. Press the button again to restart the programme. Cancelling a programme Turn the selector dial to to cancel a programme which is running. Now you can select a new programme. Opening the door after the programme has started First set the machine to pause by pressing the button 7. If the pilot light 9 goes off, the door can be opened. Use - Drying If the pilot light 9 remains lit, this means that the machine is already heating or that the water level is too high. In any case, do not force the door! If you cannot open the door but you need to open it, switch the machine off by turning the selector dial to . After a few minutes the door can be opened. (Pay attention to the water level and temperature!). After closing the door, it is necessary to select the programme and options again and to press button 7. At the end of the programme The machine stops automatically. The blinking appears on the display, the pilot light of but- ton 7 and the pilot light 9 go off. If a programme or an option that ends with water left in the tub has been selected, the pilot light 9 remains on and the door is locked to indicate that the water must be emptied out before opening the door. Before you empty out the water, the drum continues to run at regular intervals until the water draining. Follow the below instructions to empty out the water: 1. Turn the programme selector dial to . 2. Select the draining or spinning programme. 3. Reduce the spin speed if needed, by pressing the relevant button. 4. Press button 7. At the end of the programme, the door is released and can be opened. Turn the programme selector dial to to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. Drying only www.zanussi.com The recommended load size is 3 kg for cottons and linen, and 2 kg for synthetic items. 17