Zanussi ZKG7165 Product Manaul - Page 22
local Service Centre.
View all Zanussi ZKG7165 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
4. put the two ends of the inlet hose in a container and let the water flow out of the hose. 5. empty the drain pump as described in the 'Emergency emptying out' section. 6. when the drain pump is empty, install the water inlet hose again. Warning! Make sure that the temperature is more than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures. Emergency emptying out If the appliance cannot drain the water, proceed as follows to empty out the machine: 1. pull out the plug from the power socket; 2. close the water tap; 3. if necessary, wait until the water has cooled down; What to do if... 4. open the pump door; 5. place a container on the floor below the recess of the drain pump; 6. press the two levers and pull forward the drainage duct to let the water flow out; 7. when the container is full of water, put the drainage duct back again and empty the container; repeat this operation until water stops flowing out; 8. if necessary clean the pump (refer to the section 'Cleaning the pump' ); 9. close the drain pump door. When you drain the water with the emergency drain procedure, you must activate again the drain system: 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2. Start the programme to drain the water. Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that the red pilot light of button 7 blinks, one of the following alarm codes appears on the display and some acoustic signals sound every 20 seconds to indicate that the machine is not working: • : problem with the water supply. • : problem with the water draining. • : door open. Once the problem has been eliminated, press the button 7 to restart the programme. If after all checks, the problem persists, contact your local Service Centre. 22 www.zanussi.com