Zanussi ZNLN18FS1 User Manual - Page 14

Problem Possible cause Solution The compressor does not start immediately after pressing the "FastFreeze", or after changing the temperature. Door is misaligned or interferes with ventilation grill. Door does not open easily. The lamp does not work. There is too much frost and ice. Water flows on the rear plate of the refrigerator. There is too much condensed water on the rear wall of the refrigerator. The room temperature is too high. Food products placed in the appliance were too warm. The door is not closed correctly. The FastFreeze function is switched on. The compressor starts after a period of time. The appliance is not levelled. You attempted to re-open the door immediately after closing. The lamp is in stand-by mode. The lamp is defective. The door is not closed correctly. The gasket is deformed or dirty. Food products are not wrapped properly. Temperature is set incorrectly. Appliance is fully loaded and is set to the lowest temperature. Temperature set in the appliance is too low and the ambient temperature is too high. During the automatic defrosting process, frost melts on the rear plate. Door was opened too frequently. Refer to "Installation" chapter. Allow food products to cool to room temperature before storing. Refer to "Closing the door" section. Refer to "FastFreeze function" section. This is normal, no error has occurred. Refer to installation instructions. Wait a few seconds between closing and re-opening of the door. Close and open the door. Contact the nearest Authorized Service Centre. Refer to "Closing the door" section. Refer to "Closing the door" section. Wrap the food products better. Refer to "Control Panel" chapter. Set a higher temperature. Refer to "Control Panel" chapter. Set a higher temperature. Refer to "Control Panel" chapter. This is correct. Open the door only when necessary. 14