Zenith SL-5798-WH-A User Guide - Page 3
Ontrol, Nstallation
UPC - 016963579804
View all Zenith SL-5798-WH-A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Bulb Installation NOTE: When re-lamping, turn power off and let the fixture cool. ❒ To remove lamp shade, loosen set screw 2 full turns with a small flat-head screwdriver.Turn shade counterclockwise and remove. ❒ To remove bulb, pull straight out of fixture. ❒ To replace bulb, firmly push bulb pins into lamp socket until completely seated. ❒ To reinstall lamp shade, place shade on fixture and align notches on shade with tabs on fixture. Turn clockwise. Tighten set screw firmly. Wire the Light Control Mount the Light Control ❒ Place the mounting bolt through the front of the junction box cover. Push the small gasket hole over the mounting screw. ❒ Make sure the wire connectors and wires are inside the junction box. Align the mounting screw with the center hole in the mounting strap. Secure the fixture to the mounting strap. ❒ Push the rubber plug firmly into place. ❒ If not installed on a weatherproof box, caulk the wall plate and mounting surface with silicone. Push the Rubber Plug over the Mounting Screw. WARNING: Turn power off at circuit breaker Lamp Shade or fuse. ❒ Remove the existing light fixture. ❒ Install mounting strap to junction box using screws appropriate for your junction box. ❒ The plastic hanger can be used to hold the fixture while wiring. The small end of the plastic hanger can be threaded through the hole in the center of Lock Nuts Lens Set Screw Keep lamps at least 1" (2.5 cm) from the sensor. the cover plate. The small end then goes into one of the slots on the mounting strap. ❒ Adjust the lamp holders by loosening the lock nuts ❒ Thread all fixture wires through the large holes in but do not rotate the lamp holders more than 180° the gasket as shown. from the factory setting. ❒ Connect the junction box wires to the light fixture ❒ Adjust lamp shades by loosening the set screws wires as shown. Twist together and secure with several turns, turn shades counterclockwise and wire connectors. remove. Reinstall the shades in the desired position and tighten set screws. White to White Black to Black Gasket Rubber Plug Mounting Bolt Connect any fixture ground wire(s) to the junction box ground wire. 598-1309-01