Zenith SL-6053-WH User Guide - Page 10

SYMPTOM Device does not come on. Device does not turn off. Device comes on randomly. Troubleshooting Guide POSSIBLE CAUSE 1. Circuit breaker or fuse is turned off. 2. Switch on device is turned off. 3. Interrupted by another device. 4. Does not respond immediately after installation. 5. Signals from transmitter are being blocked, or transmitter is out of range. 6. Weak battery in the transmitter. 7. Dip switches on transmitter and receiver units do not match. 8. Device is defective. 1. Same as 5, 6, and 7 above. 1. Short term power line failure. 2. Another transmitter on the same frequency. SOLUTION 1. Verify circuit breaker or fuse is turned on. 2. Verify switched device is turned on. 3. Change codes on transmitter and receiver units. 4. Wait for 90 second initialization period (remote motion sensor). 5. Check for metal objects that could block the signal, or reposition the transmitter. 6. Check battery charge and replace if necessary. 7. Verify code settings on transmitter and receiver units are set the same. 8. Test using different device. 1. Same as 5, 6, and 7 above. 1. Next transmission from transmitter will reset receiver to correct state. 2. Change codes on transmitter and receiver units. Technical Service Please call 1-800-858-8501 (English speaking only) for assistance before returning product to store. If you experience a problem, follow this guide. You may also want to visit our Web site at: www.hzsupport.com. If the problem persists, call* for assistance at 1-800-858-8501 (English speaking only), 7:30 AM to 4:30 PM CST (M-F). You may also write* to: HeathCo LLC P.O. Box 90004, Bowling Green, KY 42102-9004 ATTN: Technical Service * If contacting Technical Service, please have the following information available: Model Number, Date of Purchase, and Place of Purchase. No Service Parts Available for this Product Regulatory Information This device complies with Part 15 of the FCC Rules and RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The user is cautioned that changes or modifications not expressly approved by the party responsible for regulatory compliance could void the user's authority to operate the equipment. 10 598-1306-04