Zenith SL-6053-WH User Guide - Page 6

Entry Switch Installation Note: Entry system includes a transmitter and magnet. The system can be used to signal that a door or window has been opened or to automatically turn the light on when entering a closet, attic, room, etc. 1. Remove Tab from Battery Chamber. Remove transmitter back cover from transmitter using small, flat-blade screwdriver. Gently pull tab out of battery chamber. 3. Before mounting, hold transmitter and magnet in selected location and verify operation. While holding the transmitter stationary, move the magnet away from transmitter to simulate door or window being opened. Verify red LED on transmitter flashes momentarily and receiver turns light on. Return magnet to original position simulating door or window being closed. Verify red LED on transmitter flashes momentarily and receiver turns light off. Note: If transmitter does not operate correctly, see Troubleshooting Guide. 4. Mount Transmitter. Transmitter Tab ScrewMounting:Attach transmitter back cover to wall using two short screws (provided). Snap transmitter onto back cover. CR2032 3 VOLTS CR2032 3 VOLTS Tape Mounting: Apply large piece of foam tape (provided) Flat-Head Screwdriver Battery (Type CR2032) Removing Battery Tab ON to the transmitter back cover. Stick transmitter back cover to 12 34 frame of door or window in desired position. Snap transmitter onto back cover. 5. Repeat step 4 to attach magnet to door or window. Important Considerations: • Entry transmitter components are for indoor use only. • The transmitter should be mounted on the frame of door or window (stationary surface). The magnet should be mounted on door or window (moving surface). See illustration below for moPoussniblteiDnirgectiocnos nfigurations and possible directions of movement. of Movement Transmitter Mounted On Stationary Surface Battery Replacement The entry transmitter requires a type CR2032, 3-volt lithium battery to operate. The transmitter is shipped with the battery installed. With typical use, the battery will last approximately five years. Remove battery when transmitter will not be used for an extended period of time. 1. Remove transmitter from transmitter back cover using small, flat-blade Transmitter screwdriver. 2. Carefully pry battery loose with small, flat-blade screwdriver. Battery will PossiPbMosolsefoibMlveDoveDeiimmrreeecnetcitonntistons of PossiPbolsesibDleiDrierecctitoinosns of Moof vMoevmemeennt t pop up. Flat-Blade Magnet Mounted On Moving Surface 3. Install replacement battery Screwdriver in socket plus (+) side up Mounting Configurations and Possible Directions of (see illustration). Press ON Movement down on battery until it 1 2 34 • A compatible receiver must be used to complete the system. The snaps into place. receiver should be located within 100 feet (30 m) of transmitter 4. Snap transmitter onto CR2032 Lithium Battery (maximum distance may vary depending on type of structures back cover. Battery Replacement between transmitter and receiver)P.ossible Directions 2. Select mounting location for entry otfrMaonvesmemnt itter. Note: Maximum Note: The magnet does not require a battery. gap between transmitter and magnet is 3/8" and the arrows located on the face of each component must be in alignment (see illustration). Also, the front surfaces of the transmitter and magnet must be flush. If magnet is recessed, use magnet extension and two long screws (provided) to ensure proper alignment. 3/8" MAXIMUM  598-1306-04