ZyXEL ES-3148 User Guide - Page 280

Chapter 36 Configure Clone The following table describes the labels in this screen. Table 118 Management > Configure Clone LABEL DESCRIPTION Source/ Destination Port Enter the source port under the Source label. This port's attributes are copied. Enter the destination port or ports under the Destination label. These are the ports which are going to have the same attributes as the source port. You can enter individual ports separated by a comma or a range of ports by using a dash. Example: • 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports. • 2-6 indicates that ports 2 through 6 are the destination ports. Basic Setting Select which port settings (you configured in the Basic Setting menus) should be copied to the destination port(s). Advanced Application Select which port settings (you configured in the Advanced Application menus) should be copied to the destination ports. Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Cancel Click Cancel to begin configuring this screen afresh. 280 ES-3148 User's Guide