ZyXEL LTE7490-M904 User Guide - Page 265
Status, Firmware, Upgrade, LABEL, DESCRIPTION
View all ZyXEL LTE7490-M904 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 265 highlights
Chapter 32 Firmware Upgrade The following table describes the labels in this screen. Table 115 Maintenance > Firmware Upgrade LABEL DESCRIPTION Upgrade Firmware Use these fields to upload firmware to the Zyxel Device. Restore Default Settings After Firmware Upgrade Click to enable this option that restores the factory-default to the Zyxel Device after upgrading the firmware. Note: Make sure to backup the Zyxel Device's configuration settings first in case the restore to factory-default process is not successful. Refer to Section 33.2 on page 266. Current Firmware This is the present firmware version. Version File Path Type in the location of the file you want to upload in this field or click Choose File to find it. Choose File Click this to find the .bin file you want to upload. Remember that you must decompress compressed (.zip) files before you can upload them. Upload Click this to begin the upload process. This process may take up to three minutes. After you see the firmware updating screen, wait a few minutes before logging into the Zyxel Device again. The Zyxel Device automatically restarts in this time causing a temporary network disconnect. In some operating systems, you may see the following icon on your desktop. Figure 191 Network Temporarily Disconnected After two minutes, log in again and check your new firmware version in the Status screen. If the upload was not successful, an error screen will appear. Click OK to go back to the Firmware Upgrade screen. LTE Series User's Guide 265