ZyXEL MC1000-SFP-FP User Guide - Page 16
DIP Switch 1, Install A Transceiver - connector
View all ZyXEL MC1000-SFP-FP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Chapter 2 Fiber-optic Connection Figure 6 Open The Cover 2.3 DIP Switch 1 The MC1000-SFP-FP supports Link-Fault Signaling (LFS). LFS monitors both copper and fiber segments and informs other segments if one segment goes down (the LFS LED also lights). See Section 1.1.1 on page 13 for more information on LFS. Use DIP switch 1 to enable or disable Link-Fault Signaling (LFS). The DIP switches are located on the printed circuit board inside the MC1000-SFP-FP. " Only DIP switch 1 has functionality. Ignore the other DIP switches. • Set DIP switch 1 to the OFF position when installing cables or when testing the network connection. • Set DIP switch 1 to the ON position after you've installed cables and tested that the connection is working correctly. 2.4 Install A Transceiver The MC1000-SFP-FP supports MSA (Multi-Source Agreement) compliant SFP transceivers. Inside the MC1000-SFP-FP, there is a slot for an SFP transceiver with an LC-type connector. SFP transceivers provide duplex single-mode or multi-mode connections. See the product specifications appendix for a list of transceivers supported at the time of writing. 1 Please observe the following warnings when working with transceivers! 16 MC1000-SFP-FP User's Guide