ZyXEL MM-7201 User Guide - Page 34
Interface Modules
View all ZyXEL MM-7201 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Chapter 3 Installing Cards 3.1.2 Add a Management Card (System Is On) Insert the card in the MS-7206 chassis. If there is another management card in the system, the new management card automatically becomes the standby management card. If the firmware version of the new management card is different than the firmware version of the existing management card, the new management card does not function in the system. 3.1.3 Remove a Management Card Remove the card from the MS-7206 chassis. If you remove the active management card, the standby management card takes over. 3.2 Interface Modules This section describes the steps required to add and remove interface modules. If you want to hot-swap interface modules, follow the steps below to remove the existing interface module and add the new interface module. You can install interface modules in slot 3, slot 4, slot 5, or slot 6. 3.2.1 Add an Interface Module (System Is Off) 1 Insert the card in the MS-7206 chassis. 2 Turn on the system. The system automatically detects what type of interface module is installed. You do not have to configure the Slot Setup screen. 3.2.2 Add an Interface Module (System Is On) If the same type of interface module was previously installed in the slot, insert the card in the MS-7206 chassis. If a different type of interface module was previously installed in the slot or if no interface module was previously installed in the slot, follow these steps. 34 MS-7206 User's Guide