ZyXEL P-320W Quick Start Guide - Page 15
Troubleshooting - power adapter
View all ZyXEL P-320W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
ENGLISH Internet Access Setup Complete If you have any Internet access problems, follow the on-screen instructions. Click Finish to complete the Connection Wizard. 4 Troubleshooting Note: If your computer cannot automatically communicate with the device, then see the multimedia tutorial on how to set up your computer to receive an IP address dynamically or give it a fixed one in the range specified in section 4.1. PROBLEM CORRECTIVE ACTION None of the LEDs turn on when Make sure that you have the correct power adaptor connected to the Mer you connect the Mer produkthjalp finns pa http://www.support.zyxel.se, it is plugged into an produkthjalp finns pa http:// appropriate power source. www.support.zyxel.se's power. Check all cable connections. If the LEDs still do not turn on, you may have a hardware problem. In this case, you should contact your local vendor. Cannot access the P-320W from my computer. Check the cable connection from your computer to the Mer produkthjalp finns pa http://www.support.zyxel.se. If the Mer produkthjalp finns pa http://www.support.zyxel.se's IP address has changed, then enter the new one as the website address. Make sure your computer's IP address is in the same subnet as the Mer produkthjalp finns pa http://www.support.zyxel.se's IP address (see section 4.1). Ping the P-320W from a computer on the LAN. Make sure your computer's Ethernet adapter is installed and functioning properly. In the computer, click Start, (All) Programs, Accessories and then Command Prompt. In the Command Prompt window, type "ping" followed by the Mer produkthjalp finns pa http://www.support.zyxel.se's LAN IP address (192.168.1.1 is the default) and then press [ENTER]. The P-320W should reply; otherwise see section 4.1. 16