ZyXEL PLA-470 Quick Start Guide - Page 8

If the HomePlug, Occasionally all lights may blink at the same time and

Get ZyXEL PLA-470 PDF manuals and user guides View all ZyXEL PLA-470 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

ENGLISH 2 Press the ENCRYPT button at the rear of your powerline device for 1-2 seconds. The power ( ) light will blink as the powerline device tries to set up a connection. 1...2 1...2 • If the power ( ) light does not blink, you have probably pressed the ENCRYPT button for too long. Try again, pressing the ENCRYPT button for 1-2 seconds. 3 Repeat step 2 in this section for the other powerline device you wish to connect. This must be done within 120 seconds of pressing the ENCRYPT button on the PLA470. 4 Check the lights on the two powerline devices. The power ( ) and HomePlug ( ) lights should be blinking. Occasionally all lights may blink at the same time and the HomePlug ( ) light may also show red. Wait for roughly one minute while your powerline devices connect. • If the HomePlug ( ) lights on both powerline devices do not light up, the powerline devices are not connected. Repeat steps 2 and 3 in this section. If that doesn't work, 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
8
ENGLISH
2
Press the
ENCRYPT
button at the rear of your powerline
device for 1-2 seconds. The power (
) light will blink as
the powerline device tries to set up a connection.
•
If the power (
) light does not blink, you have probably
pressed the
ENCRYPT
button for too long. Try again, press-
ing the
ENCRYPT
button for 1-2 seconds.
3
Repeat step
2
in this section for the other powerline
device you wish to connect. This must be done within 120
seconds of pressing the
ENCRYPT
button on the PLA470.
4
Check the lights on the two powerline devices. The power
(
) and HomePlug (
) lights should be blinking.
Occasionally all lights may blink at the same time and the
HomePlug (
) light may also show red. Wait for roughly
one minute while your powerline devices connect.
•
If the HomePlug (
) lights on both powerline devices do
not light up, the powerline devices are not connected.
Repeat steps
2
and
3
in this section. If that doesn’t work,
1...2
1...2