ZyXEL PLA5405 v2 User Guide - Page 47
Configuration Utility Problems, Zyxel PLA Series Configuration
View all ZyXEL PLA5405 v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Chapter 6 Troubleshooting 3 Make sure that all your powerline adapters are HomePlug AV compliant. Check the package it came in or ask your vendor. This PLA can not detect earlier versions of HomePlug powerline adapters such as HomePlug 1.0 or 1.0.1. (Although they can coexist on the same electrical wiring without interfering with each other.) 4 Make sure that the powerline adapters on your network are all on the same electrical wiring. Connect another powerline adapter into an outlet close to your PLA's power outlet. They are probably now on the same electrical wiring. Check the HomePlug ( ) light. If it now lights up your powerline adapter was probably previously on separate electrical wiring. Ask an electrician for more information on the electrical wiring in your building. 5 Make sure that you do not have a power meter between powerline adapters. Powerline signals cannot pass this. The POWER and HomePlug light blink at the same time. • You have pressed the RESET/ENCRYPT button for more than three seconds. Try setting up a connection again, this time pressing the RESET/ENCRYPT buttons on both devices for less than three seconds. 6.2 Configuration Utility Problems The Zyxel PLA Series Configuration utility displays an error during installation. • Make sure your computer is using the supported operating system. See Section 3.1.1 on page 19 and/ or Section 3.2.1 on page 25 for more information. The Zyxel PLA Series Configuration utility does not display all or any of my devices. • Inspect the LEDs on your PLA and make sure that the ETHERNET and HomePlug LEDs are on or blinking. See Section 1.2 on page 7 for troubleshooting LED related problems. • Check you are using the latest version utility. Earlier version utilities cannot communicate with PLAs using the latest firmware. If you do not have the latest utility, download it from the Zyxel website. • If you are running another tool such as the Firmware Detection Tool, the utility will not detect your local device. • If your computer has more than one network interface card (NIC), make sure you select the right NIC to which the PLA is connected in the utility's Configuration screen. PLA Series User's Guide 47