eMachines T3092 NG3 Hardware Reference - Page 171
Slide the old drive out of the bay., the two screws on one side of the bay are shown below.
UPC - 764296108993
View all eMachines T3092 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 171 highlights
CHAPTER 13: Adding and Replacing Components www.emachines.com 4 Remove the screw that secures the hard drive bay to the case. Screw 5 Slide the hard drive bay away from the system board and toward the open side of the case, then remove the hard drive bay from the case. 164 6 If you are adding a new drive, go to Step 9. If you are replacing an existing drive, go to the next step. 7 Remove the four screws that secure the hard drive to the drive bay. (Only the two screws on one side of the bay are shown below.) Screws 8 Slide the old drive out of the bay. 9 Slide the new drive into the drive bay. 10 Use the four screws you removed previously to secure the hard drive to the hard drive bay.
CHAPTER 13: Adding and Replacing Components
www.emachines.com
164
4
Remove the screw that secures the hard drive bay to the case.
5
Slide the hard drive bay away from the system board and toward the open
side of the case, then remove the hard drive bay from the case.
6
If you are adding a new drive, go to
Step 9
. If you are replacing an existing
drive, go to the next step.
7
Remove the four screws that secure the hard drive to the drive bay. (Only
the two screws on one side of the bay are shown below.)
8
Slide the old drive out of the bay.
9
Slide the new drive into the drive bay.
10
Use the four screws you removed previously to secure the hard drive to
the hard drive bay.
Screw
Screws