eMachines T3092 NG3 Hardware Reference - Page 177
Rotate the I/O panel up until its screw hole aligns with the screw hole in, the front of the case
UPC - 764296108993
View all eMachines T3092 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 177 highlights
CHAPTER 13: Adding and Replacing Components www.emachines.com 5 Disconnect the front I/O panel cables from the system board. 170 6 Remove the single screw that secures the front I/O panel to the case. Screw 7 Rotate the I/O panel down until it faces the tabletop, then pull the I/O panel and its cables away from the case. Note the location of the hole through which the cables are threaded. 8 Thread the new I/O panel's cables through the hole in the case, then insert the tabs in the bottom of the I/O panel into the slots in the front of the case. 9 Rotate the I/O panel up until its screw hole aligns with the screw hole in the front of the case, then secure it to the case with the screw. 10 Reconnect the I/O panel's cables to the appropriate connectors on the system board.