eMachines eView_17s User Guide - Page 5

3.2 Signal connector pin assignment Pin Assignment 1 Red Video 2 Green Video 3 Blue Video 4 Ground 5 Ground 6 Red Ground 7 Green Ground 8 Blue Ground Pin Assignment 9 No connection 10 Ground 11 Ground 12 SDA For DDC 13 H. Sync. 14 V. Sync. 15 SCL For DDC 4. Troubleshooting If your monitor is not performing properly, use the following troubleshooting for quick solutions to common problems, If the problem persists, call the dealer. Where you purchased the monitor. No Picture: Please check these items. Power cord and signal cable are securely connected. Monitor in power save mode? Adjust the brightness and contrast controls. Display image is too large or small: Use the function keys to adjust the image. Picture is scrolling or unstable: Signal cable should be completely attached to the computer. Check the signal cable pin assignments incorrect? Color is abnormal: Magnetic object nearby? Signal cable pin assignments incorrect? Signal cable properly connected? Image is not correctly shaped: A new video mode is selected. User control has not yet been adjusted. Use the function keys to adjust image. Page 6 FEDERAL COMMUNICATIONS COMMISSION(F.C.C)STATEMENT This equipment has been tested and found to comply with the limits of a Class B digital device. Pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient/Relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4. Consult the dealer or an experienced radio/TV technician for help. CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment. NOTE: The use of a non-shielded interface cable with this equipment is prohibited.