2003 Buick Rendezvous Owner's Manual - Page 150

Memory Seat If your vehicle has this feature, the controls are located on the driver's door Dane1 and are used to program and recall the driver's seat position and outside rearview mirror position. To recall your memory positions, your vehicle must be in PARK (P). Push and release the memory button (1 or 2) corresponding to the desired driving position. The seat and the outside rearview mirrors will move to the position previously stored for the identified driver. you will hear one beep. You can also store an exit position for each driver. The exit position is programmed by moving the seat to the desired exit position and then holding the exit symbol button for more than three seconds. The exit position set will be for the most recently selected driving position (1 or 2). A double beep will sound when the memory is set. To use exit, your vehicle must be in PARK (P). Push and release the exit symbol button and the seat will move to the exit position stored for the most recently selected driver. You will hear one beep. To stop recall movement of the seat at any time, press one of the three memory buttons or one of the power seat controls located on the outboard side of the driver's seat. Adjust the driver's seat and the outside rearview mirrors to the position you would like for driving. Then press and hold memory button 1 for more than three seconds. A double beep will sound when the memory seat and mirrors are set. To set the seat and outside rearview mirrors for a capnnrl rlri\mr , fnllnw thn nrcr\linlIC-stone hrlt ~ r e s s r button 2 instead. "VVVlIU U,,.". I..,,-.. I..- r - 7 If your vehicle is equipped with a Driver Information Center (DIC), you can use it to program certain functions of the memory seats. See DIC Vehicle Personalization on page 3-59. 2-57